can not startup bus!

The view buttons work, but not the buttons on the keyboard that controls the functions of the bus, I can click on the dashboard buttons with the mouse. The motor turns over for a few seconds, then nothing!

flat battery?

When starting up the engine:
stick in the key
change the gear to Neutral
press the start-up
change the gear to Drive
release the handbrake
GO.

peterZZD schrieb:

When starting up the engine:
stick in the key
change the gear to Neutral
press the start-up
change the gear to Drive
release the handbrake
GO.

or press, E then N then M then D and release handbrake to do exactly the same thing

But he said that the engine is turning over so the ignition must be on. Which bus are you trying to start up?

The problem is usually the gearbox which wasn't changed to Neutral before starting. Make sure your gear is in Neutral, otherwise it won't start up (had the same problem a couple of times...).

peterZZD schrieb:

The problem is usually the gearbox which wasn't changed to Neutral before starting. Make sure your gear is in Neutral, otherwise it won't start up (had the same problem a couple of times...).

I've done that a few times I sat there scratching my head & wondering why the damn thing wouldn't start.

Electrics on? (the key you put in)

Try this troubleshooting method;

- Set up a new bus, from one of the starting points.

- If you see numbers etc on the IBIS it means electricity is already on.

- If no numbers etc are the IBIS, press E to switch on the electrics.

- Ensure parking break is set on (you can just check visually that it's 'pulled back').

- Press 'N' key to ensure bus is in Neutral.

- Press 'M' and the engine should start.

- If it doesn't, press [NUM-] to activate the door break in case this was not set.

- Try pressing 'M' again to start the engine.

- If still not starting, you have an issue and may perhaps need to reinstall.

cheers,

davidrogers schrieb:

If it doesn't, press [NUM-] to activate the door break in case this was not set.

This is not necessary! You just have to verify that electricity is on and you are on "N" mode (just press [N], if it clicks, then you were NOT in [N] mode )

1. Press E
2. Press N
3. Press M

It cant be more easy. I can startup bus in 2-3 sec.